?
Back
Save
LED & Hardware setup
Total LEDs:
?
Recommended power supply for brightest white:
?
Enable automatic brightness limiter:
Maximum Current:
mA
⚠ Your power supply provides high current.
To improve the safety of your setup,
please use thick cables,
multiple power injection points and a fuse!
Automatically limits brightness to stay close to the limit.
Keep at <1A if powering LEDs directly from the ESP 5V pin!
If you are using an external power supply, enter its rating.
(Current estimated usage:
unknown
)
LED voltage (Max. current for a single LED):
5V default (55mA)
5V efficient (35mA)
12V (30mA)
WS2815 (12mA)
Custom
Custom max. current per LED:
mA
Keep at default if you are unsure about your type of LEDs.
Hardware setup
LED outputs:
+
-
LED Memory Usage:
0
/
?
B
⚠ You might run into stability or lag issues.
Use less than
800 LEDs per output
for the best experience!
Make a segment for each output:
Custom bus start indices:
White Balance correction:
Calculate CCT from RGB:
CCT additive blending:
%%
Touch threshold:
IR GPIO:
Remote disabled
24-key RGB
24-key with CT
40-key blue
44-key RGB
21-key RGB
6-key black
9-key red
JSON remote
×
JSON file:
IR info
Relay GPIO:
Invert
×
Defaults
Turn LEDs on after power up/reset:
Default brightness:
(0-255)
Apply preset
at boot (0 uses defaults)
Use Gamma correction for color:
(strongly recommended)
Use Gamma correction for brightness:
(not recommended)
Brightness factor:
%%
Transitions
Crossfade:
Transition Time:
ms
Enable Palette transitions:
Timed light
Default Duration:
min
Default Target brightness:
Mode:
Wait and set
Fade
Fade Color
Sunrise
Advanced
Palette blending:
Linear (wrap if moving)
Linear (always wrap)
Linear (never wrap)
None (not recommended)
Config template:
Back
Save