?
Back
Save
LED & Hardware setup
Total LEDs:
?
Recommended power supply for brightest white:
?
Enable automatic brightness limiter:
Automatically limits brightness to stay close to the limit.
Keep at <1A if poweing LEDs directly from the ESP 5V pin!
Analog (PWM) and virtual LEDs cannot use automatic brightness limiter.
Maximum PSU Current:
mA
Use per-output limiter:
Make sure you enter correct values in each LED output.
If using multiple outputs with only one PSU, distribute its power proportionally amongst ouputs.
⚠ Your power supply provides high current.
To improve the safety of your setup,
please use thick cables,
multiple power injection points and a fuse!
Hardware setup
LED outputs:
+
-
LED Memory Usage:
0
/
?
B
⚠ You might run into stability or lag issues.
Use less than
800 LEDs per output
for the best experience!
Make a segment for each output:
Custom bus start indices:
Use global LED buffer:
Color Order Override:
+
-
Disable internal pull-up/down:
Touch threshold:
IR GPIO:
Remote disabled
24-key RGB
24-key with CT
40-key blue
44-key RGB
21-key RGB
6-key black
9-key red
JSON remote
✕
Apply IR change to main segment only:
JSON file:
Upload
IR info
Relay GPIO:
Invert
✕
Defaults
Turn LEDs on after power up/reset:
Default brightness:
(0-255)
Apply preset
at boot (0 uses defaults)
Use Gamma correction for color:
(strongly recommended)
Use Gamma correction for brightness:
(not recommended)
Use Gamma value:
Brightness factor:
%
Transitions
Crossfade:
Effect blending:
Transition Time:
ms
Enable Palette transitions:
Random Cycle
Palette Time:
s
Timed light
Default Duration:
min
Default Target brightness:
Mode:
Wait and set
Fade
Fade Color
Sunrise
White management
White Balance correction:
Global override for Auto-calculate white:
Disabled
None
Brighter
Accurate
Dual
Max
Calculate CCT from RGB:
CCT additive blending:
%
Advanced
Palette blending:
Linear (wrap if moving)
Linear (always wrap)
Linear (never wrap)
None (not recommended)
Target refresh rate:
FPS
Config template:
Apply
Back
Save