LED & Hardware setup

Total LED count:
Recommended power supply for brightest white:
?


Enable automatic brightness limiter:
Maximum Current: mA
Automatically limits brightness to stay close to the limit.
Keep at <1A if powering LEDs directly from the ESP 5V pin!
If you are using an external power supply, enter its rating.
(Current estimated usage: unknown)


LED voltage (Max. current for a single LED):

Keep at default if you are unsure about your type of LEDs.

Hardware setup

LED outputs:

LED Memory Usage: 0 / ? B

Button pin:  ×
IR pin:  ×
Relay pin:  ×
Active high

Defaults

Turn LEDs on after power up/reset:
Default brightness: (0-255)

Apply preset at boot (0 uses defaults)
- or -
Set current preset cycle setting as boot default:

Use Gamma correction for color: (strongly recommended)
Use Gamma correction for brightness: (not recommended)

Brightness factor: %

Transitions

Crossfade:
Transition Time: ms
Enable Palette transitions:

Timed light

Default Duration: min
Default Target brightness:
Mode:

Advanced

Palette blending:
Skip first LED:
Auto-calculate white channel from RGB: