/* * Settings html (part 1) */ const char PAGE_settings0[] PROGMEM = R"=====( Settings

WLED Settings

WiFi setup

Configure Access Point

AP SSID (leave empty for no AP):

Hide AP SSID:
AP password (leave empty for open):

AP channel:
AP IP: Not active

Application setup

Web setup

Server description:
Use HSB sliders instead of RGB by default:

LED setup

LED count (max. 255):
The default boot color is saved in preset slot 0.
Alternatively, apply preset at boot
Default RGB color:
Default brightness: (0-255)
Default white value (only RGBW, -1 to disable):
Default effect ID:
Default effect speed:
Ignore and use current color, brightness and effects:
Turn on after power up/reset:
Use Gamma correction for brightness:
Use Gamma correction for color:
Brightness factor: %

Button setup

On/Off button enabled:

Transitions

Fade:
Sweep: Invert direction:
Transition Delay: ms

Timed light

Target brightness: (0-255)
Change after: min
Fade:

Broadcast

UDP Port:
Receive notifications:
Send notifications on direct change:
Send notifications on button press:

Interfaces

Emulate Alexa device:
Alexa invocation name:
Send Alexa notifications:

Time (experimental!)

NTP was updated but still causes crashes. Requires reboot.
Get time from NTP server:
Current local time is unknown

Advanced

Default overlay ID:
WARLS offset: negative

Security

OTA locked:
Passphrase:
To enable OTA, for security reasons you need to also enter the correct password!
The password may/should be changed when OTA is enabled.
Disable OTA when not in use, otherwise an attacker could reflash device software!

Disable recovery AP:
In case of a connection error there will be no wireless recovery possible!
Completely disables all Access Point functions.
Setting only changable if OTA is enabled!

Factory reset:
All EEPROM content (settings) will be erased.

HTTP traffic is not encrypted. An attacker in the same network could intercept form data!

About

WLED version 0.4p
(c) 2016-2017 Christian Schwinne
Licensed under the MIT license

Uses libraries:
ESP8266 Arduino Core
WS2812FX by kitesurfer1404 (Aircoookie fork)
Timezone library by JChristensen
arduino-esp8266-alexa-multiple-wemo-switch by kakopappa

UI icons by Linearicons created by Perxis! (CC-BY-SA 4.0)

Server message: XML response error!

)====="; /* * Settings set html */ const char PAGE_settingssaved[] PROGMEM = R"=====( Saved Settings

Settings saved.

If you made changes to WiFi configuration, please reboot.

)=====";