WLED Settings

WiFi setup

Connect to existing network

Network SSID (leave empty to not connect):

Network password:

Static IP (leave at 0.0.0.0 for DHCP):
. . .
Static gateway:
. . .
Static subnet mask:
. . .
mDNS address (leave empty for no mDNS):
http:// .local
Client IP: Not connected

Configure Access Point

AP SSID (leave empty for no AP):

Hide AP SSID:
AP password (leave empty for open):

AP channel:
AP IP: Not active

Application setup

Web setup

Server description:

LED setup

Default RGB color:
Default brightness: (0-255)
Default effect ID:
Default effect speed:
Ignore and use current color, brightness and effects:
Brightness factor: %

Button setup

On/Off button enabled:

Transitions

Fade:
Transition Delay: ms

Timed light

Target brightness: (0-255)
Change after: min
Fade:

Daisy chain

UDP Port:
Receive notifications:
Send notifications on direct change:
Send notifications on button press:
Send nightlight notifications:

Time

Get time from NTP server:
Current local time is unknown

Security

OTA locked:
Passphrase:
To enable OTA, for security reasons you need to also enter the correct password!
The password may/should be changed when OTA is enabled.
Disable OTA when not in use, otherwise an attacker could reflash device software!

Disable recovery AP (Not implemented):
In case of a connection error there will be no wireless recovery possible!
Completely disables all Access Point functions.

Factory reset:
All EEPROM content (settings) will be erased.

HTTP traffic is not encrypted. An attacker in the same network could intercept form data!

About

WLED version 0.3pd
(c) 2016 Christian Schwinne
Server message: XML response error!