?
Back
Save
LED & Hardware setup
Total LED count:
⚠ You might run into stability or lag issues.
Use less than 1000 LEDs per ESP for the best experience!
Recommended power supply for brightest white:
?
Enable automatic brightness limiter:
Maximum Current:
mA
⚠ Your power supply provides high current.
To improve the safety of your setup,
please use thick cables,
multiple power injection points and a fuse!
Automatically limits brightness to stay close to the limit.
Keep at <1A if powering LEDs directly from the ESP 5V pin!
If you are using an external power supply, enter its rating.
(Current estimated usage:
unknown
)
LED voltage (Max. current for a single LED):
5V default (55mA)
5V efficient (35mA)
12V (30mA)
WS2815 (12mA)
Custom
Custom max. current per LED:
mA
Keep at default if you are unsure about your type of LEDs.
Auto-calculate white channel from RGB:
None
Brighter
Accurate
Dual
Legacy
Hardware setup
LED outputs:
+
-
Relay pin:
Active high?
Button pin:
IR pin:
AUX pin:
Defaults
Turn LEDs on after power up/reset:
Default brightness:
(0-255)
Apply preset
at boot (0 uses defaults)
-
or
-
Set current preset cycle setting as boot default:
Use Gamma correction for color:
(strongly recommended)
Use Gamma correction for brightness:
(not recommended)
Brightness factor:
%
Transitions
Crossfade:
Transition Time:
ms
Enable Palette transitions:
Timed light
Default Duration:
min
Default Target brightness:
Mode:
Wait and set
Fade
Fade Color
Sunrise
Advanced
Palette blending:
Linear (wrap if moving)
Linear (always wrap)
Linear (never wrap)
None (not recommended)
Reverse LED order (rotate 180):
Skip first LED:
Back
Save