WLED Settings
WiFi setup
Connect to existing network
Network SSID (leave empty to not connect):
Network password:
Static IP (leave at 0.0.0.0 for DHCP):
.
.
.
Static gateway:
.
.
.
Static subnet mask:
.
.
.
mDNS address (leave empty for no mDNS):
http://
.local
Client IP:
Not connected
Configure Access Point
AP SSID (leave empty for no AP):
Hide AP SSID:
AP password (leave empty for open):
AP channel:
AP IP:
Not active
Application setup
LED setup
The default boot LED color is the current color when settings are saved.
LED amount:
Button setup
On/Off button enabled:
Transitions
Fade:
Transition Delay:
ms
Timed light
Turn off after:
min
Fade down:
Daisy chain
Receive notifications:
Received brightness factor:
%
Send notifications on direct change:
Send notifications on button press:
Forward received notifications:
Hosts to send notifications to: (1 IP per line)
Security
OTA locked:
Passphrase:
To enable OTA, for security reasons you need to also enter the correct password!
The password may/should be changed when OTA is enabled.
Disable OTA when not in use, otherwise an attacker could reflash device software!
Disable recovery AP (
Not implemented
):
In case of a connection error there will be no wireless recovery possible!
Completely disables all Access Point functions.
Factory reset:
All EEPROM content (settings) will be erased.
HTTP traffic is not encrypted. An attacker in the same network could intercept form data!
About
WLED version 0.3pd
(c) 2016 Christian Schwinne
Server message:
XML response error!