WLED Settings
WiFi setup
Connect to existing network
Network SSID (leave empty to not connect):
Network password:
Static IP (leave at 0.0.0.0 for DHCP):
.
.
.
Static gateway:
.
.
.
Static subnet mask:
.
.
.
mDNS address (leave empty for no mDNS):
http://
.local
Client IP:
Not connected
Configure Access Point
AP SSID (leave empty for no AP):
Hide AP SSID:
AP password (leave empty for open):
AP channel:
AP IP:
Not active
Application setup
Web setup
Server description:
LED setup
The default boot LED color is the current color when settings are saved.
Brightness factor:
%
Button setup
On/Off button enabled:
Transitions
Fade:
Transition Delay:
ms
Timed light
Target brightness:
(0-255)
Change after:
min
Fade:
Daisy chain
UDP Port:
Receive notifications:
Send notifications on direct change:
Send notifications on button press:
Send nightlight notifications:
Security
OTA locked:
Passphrase:
To enable OTA, for security reasons you need to also enter the correct password!
The password may/should be changed when OTA is enabled.
Disable OTA when not in use, otherwise an attacker could reflash device software!
Disable recovery AP (
Not implemented
):
In case of a connection error there will be no wireless recovery possible!
Completely disables all Access Point functions.
Factory reset:
All EEPROM content (settings) will be erased.
HTTP traffic is not encrypted. An attacker in the same network could intercept form data!
About
WLED version 0.3pd
(c) 2016 Christian Schwinne
Server message:
XML response error!