WLED Settings
WiFi setup
Connect to existing network
Network SSID (leave empty to not connect):
Network password:
Static IP (leave at 0.0.0.0 for DHCP):
.
.
.
Static gateway:
.
.
.
Static subnet mask:
.
.
.
mDNS address (leave empty for no mDNS):
http://
.local
Try connecting before opening AP for:
s
Client IP:
Not connected
Configure Access Point
AP SSID (leave empty for no AP):
Hide AP SSID:
AP password (leave empty for open):
AP channel:
AP IP:
Not active
Application setup
Web setup
Server description:
Use HSB sliders instead of RGB by default:
LED setup
LED count (max. 255):
The default boot color is always saved in preset slot 0.
Alternatively, apply preset
at boot
Default RGB color:
Default brightness:
(0-255)
Default white value (only RGBW, -1 to disable):
Default effect ID:
Default effect speed:
Ignore and use current color, brightness and effects:
Turn on after power up/reset:
Use Gamma correction for brightness:
Use Gamma correction for color:
Brightness factor:
%
Button setup
On/Off button enabled:
Transitions
Fade:
Sweep:
Invert direction:
Transition Delay:
ms
Timed light
Target brightness:
(0-255)
Change after:
min
Fade:
Broadcast
UDP Port:
Receive notifications:
Send notifications on direct change:
Send notifications on button press:
Interfaces
Emulate Alexa device:
Alexa invocation name:
Send Alexa notifications:
Time (experimental!)
Requires reboot.
Get time from NTP server:
Current local time is
unknown
Advanced
Default overlay ID:
WARLS offset:
Security
OTA locked:
Passphrase:
To enable OTA, for security reasons you need to also enter the correct password!
The password may/should be changed when OTA is enabled.
Disable OTA when not in use, otherwise an attacker could reflash device software!
Disable recovery AP:
In case of a connection error there will be no wireless recovery possible!
Completely disables all Access Point functions.
Setting only changable if OTA is enabled!
Factory reset:
All EEPROM content (settings) will be erased.
HTTP traffic is not encrypted. An attacker in the same network could intercept form data!
About
WLED version 0.5dev
(c) 2016-2018 Christian Schwinne
Licensed under the MIT license
Uses libraries:
ESP8266 Arduino Core
WS2812FX by kitesurfer1404 (Aircoookie fork)
Timezone library by JChristensen
arduino-esp8266-alexa-multiple-wemo-switch by kakopappa
UI icons by
Linearicons
created by
Perxis
! (CC-BY-SA 4.0)
Server message:
XML response error!