7e01d113d8
* Adding new usermod for TTGO T-DIsplay. * Finalizing the code * Modified and cleaned up readme.md file * Fixes to platformio.ini to restore back to previous state * Cleaned up comments in usermod file |
||
|---|---|---|
| .. | ||
| assets | ||
| platformio_override.ini | ||
| README.md | ||
| usermod.cpp | ||
TTGO T-Display ESP32 with 240x135 TFT via SPI with TFT_eSPI
This usermod allows use of the TTGO T-Display ESP32 module with integrated 240x135 display for controlling WLED and showing the following information:
- Current SSID
- IP address if obtained
- in AP mode and turned off lightning AP password is shown
- Current effect
- Current palette
Usermod based on a rework of the ssd1306_i2c_oled_u8g2 usermod from the WLED repo.
Hardware
Github reference for TTGO-Tdisplay
Requirements
Functionality checked with:
- TTGO T-Display
- PlatformIO
- Group of 4 individual Neopixels from Adafruit, and a full string of 68 LEDs.
Platformio Requirements
Platformio.ini changes
Under the root folder of the project, in the platformio.ini file, uncomment the TFT_eSPI line within the [common] section, under lib_deps:
# platformio.ini
...
[common]
...
lib_deps =
...
#For use of the TTGO T-Display ESP32 Module with integrated TFT display uncomment the following line
#TFT_eSPI
...
Platformio_overrides.ini (added)
Copy the platformio_overrides.ini file which is contained in the usermods/TTGO-T-Display/ folder into the root of your project folder. This file contains an override that remaps the button pin of WLED to use the on-board button to the right of the USB-C connector (when viewed with the port oriented downward - see hardware photo).
TFT_eSPI Library Adjustments (board selection)
NOTE: I am relatively new to Platformio and VS Code, but I find that in order to get the project populated with the TFT_eSPI library (so the following changes can be made), I need to attempt an initial build that I know will fail. There is probably a better way to accomplish this, but it worked for me. Once the first build fails, the User_Setup_Select.h file can be found in the /.pio/libdeps/esp32dev/TFT_eSPI_ID1559 folder.
Modify the User_Setup_Select.h file as follows:
- Comment out the following line (which is the 'default' setup file):
//#include <User_Setup.h> // Default setup is root library folder
- Uncomment the following line (which points to the setup file for the TTGO T-Display):
#include <User_Setups/Setup25_TTGO_T_Display.h> // Setup file for ESP32 and TTGO T-Display ST7789V SPI bus TFT
Run the build again and it should complete correctly.
Arduino IDE
- UNTESTED